VALKO Dealers area


From this area you may ask for an offer.
Insert your ID to log in the private area

Required field

Required field

Access

Contact us

Required field

Required field

Required field

Required field

Required field

Required field

Required field

Required field

Required field

Required field

Required field

In compliance with the art. 13 of the Italian Legislative Decree no. 196 dated 2003 and with the art.13 GDPR 679/16 I hereby authorize the use and process of my personal data
Sending you this form which I personally filled in, pursuant to the articles 7, 13 and 23 of the D.Lgs. n.196/2003, I declare to be aware of the privacy policy by Sartoria Saintandrews Milano spa, to be exhaustively informed about my rights and to be aware of how and where to exercise them, therefore I GIVE MY CONSENT to Sartoria Saintandrews Milano spa for the treatment of the information released for the specified purposes in the aforementioned policy.

Oil change

For the pump oil replacement proceed as follows:
1. Put the vacuum machine on a level surface allowing an easy access to the rear.
2. Remove the back panel by losing the relative screws.

DRAINING USED OIL
After switching off the vacuum pump at normal operating temperature wait no more than 20 minutes before the oil is drained (the oil shall still be warm when being drained).
• Make sure that the vacuum pump is shut down and locked against inadvertent start up
• Make sure that the vacuum pump is vented to atmospheric pressure
• Put a drain tray underneath the sight glass
• Remove the sight glass and drain the oil

When the oil stream dwindles:
• Reinsert the sight glass
• Switch the vacuum pump on for a few seconds
• Make sure that the vacuum pump is shut down and locked against inadvertent start up
• Remove the sight glass again and drain the remaining oil
• Make sure that the seal ring is inserted into the drain plug and undamaged, replace if necessary
• Firmly reinsert the drain plug together with the seal ring
• Dispose of the used oil in compliance with applicable regulations
WARNING: Never use the drained oil again.

FILLING IN FRESH OIL
NOTE: In order to make a better cleaning of the inner part of the pump unscrew the loading plug and blow compressed air in the pump.
The amount given in these operating instructions is a guide. The sight glass indicates the actual amount to be filled in.
• Make sure that the drain plug is firmly inserted
• Remove the filling plug
• Fill in approx. 0.4 liters of oil
• Make sure that the level is at about 75 percent of the sight glass
• Make sure that the seal ring is inserted into the filling plug and undamaged, replace if necessary
• Firmly reinsert the filling plug together with the seal ring

OIL CONTROL
Periodically check the oil window of the pump: a level higher than the maximum can obstruct the filter, while a level lower than the minimum can cause a low vacuum degree and damage the pump.

This site use a Cookie to offer a better experience. Going trought the navigation you accepting to use our cookies.

More info Close

Web Design, Art Direction and Web Programming / FRI-WEB; The pictures are protected by the law of copyright and it is illegal to use them without a written permission.